Charnwood B250 10'' Premium Wood Bandsaw c/w Stand

A compact floorstanding woodworking bandsaw with a massive cutting capacity, for a machine of this size and price, of 150mm (6"). The big capacity makes it an ideal choice for woodworkers who are short on space. The power is delivered by a quiet induction motor with a belt drive to the bandsaw wheel. The key to straight and accurate cutting on a bandsaw is to have a good set of blade guides. The B250 has three sealed bearings on the blade guard. Two mounted side-on to the blade to control blade twist and keep it true. The rear bearing takes the thrust of the back of the blade allowing it to run freely. The same setup is then repeated beneath the table. The cast iron table tilts from 90 degrees to 45 degrees and has a positive stop at both of those positions. Any angle in between can be read off the scale and locked in. For rip cuts the guide fence can be situated on either side of the blade, can be locked into position with a single press of the lever and has a clear marker to set against the metric scale. The fence itself can be fitted in two ways. When cutting thicker material the full face height of 60mm is used. When cutting thin and narrow strips the fence is fitted with the small face, against the blade to allow clearance around the guides. Supplied with 3/8'' x 6tpi blade, rip fence, mitre fence, work light, floorstand, 1.8m power cable and UK 3 pin plug. Specification: Motor (Induction): 375w (1/2hp) Maximum Cutting Depth: 150mm (6") Throat Width: 245mm (10") Table Size: 360mm x 320mm Table Height: 940mm Table Tilt: 90-45 degrees Cutting Speeds: 400 & 800m/min Blade Length: 1826mm Blade Widths: 6-12mm (1/4" - 1/2") Dimensions (WxDxH): 670mm x 530mm x 1450mm Weight: 41Kg 12 Months Guarantee! Visit our Store: Mallow Tools Ballinamona Shanballymore Mallow Co. Cork P51 HX06 Tel: 022-40656 Website: www.mallowtools.ie