Ladegerat Battery Charger

If you want, you can get a lead battery with it as well. Here is the description from a website I found: The A910/6 battery charger is used for charging lead–acid batteries of the starter or service (gel) type for continuous use and in a buffer system connection: It can remain permanently connected to the 230 V mains, as the system automatically selects the charging mode depending on the battery status. If the battery is not connected with at least 3 V, the system will not operate. The charging system works in three cycles: Charge the battery with maximum current until the final charge voltage of 14.5 V is reached (red LED). Note: The end of the charging process is only reached if the battery is in good condition. Timed final charging phase at a constant 14.5 V for a duration of: – 20 minutes (Pb battery) – 6 hours and 20 minutes (gel/AGM battery) Maintenance charge at a constant 13.8 V (green LED), ensuring the necessary trickle current for full charge. In this phase, the system distributes the thyristors so that the voltage spike is reduced to almost zero. If the battery voltage drops below approx. 13.6 V, including due to a load being applied, the system restarts from phase 2. An electronic device disconnects all 12 V consumers when the service battery reaches the minimum voltage level of 10 V. You can restore it for about one minute by switching the main switch on the control panel off and on again. The three-way refrigerator, the electric step, and the heater/boiler are excluded from this device. Note: Product not compatible with A910-6AF. We can send the A910-6AF model to CBE for repair.