Fluke 789 Process meter & Fluke 773 Milliamp clamp

Both meters in excellent condition. Never used on site and only for training and demonstrations. Asking for 700 each or 1250 for the pair FLUKE 789 Multi Function Calibrator Features 18°C to 28 °C temperature range (for 1 year after calibration) Diode test 2.000 V (shows diode voltage drop) Simultaneous mA and % scale readout Up to 20 kHz frequency measurement Min/Max/Average/Hold/Relative modes Continuity beeper HART mode setting with loop power (adds 250 ohm resistor) 20 mA dc current source/measure/simulate Fluke 773 Best in class 0.2% accuracy • 0.01 mA resolution and sensitivity • Measure 4 to 20 mA signals without “breaking the loop” • Measure mA signals for PLC and control system analog I/O • Dual backlit display with both mA measurement and percent of 4 to 20 mA span • Measurement Spotlight illuminates hard to see wires in dark enclosures • Detachable clamp with extension cable for measurements in tight locations • Measure 10 to 50 mA signals in older control systems using the 99.9 mA range • Automatically change the 4 to 20 mA output for remote testing • Power saving features, auto-off, backlight timeout extend battery life • Hold function captures and displays changing measurements • Measure 4 to 20 mA signals with in-circuit measurement • Simultaneous mA in-circuit measurement with 24V loop power for powering and testing transmitters • Source 4 to 20 mA signals for testing control system I/O or I/Ps • mA output linear ramp or 25% step output • Automatically change the 4 to 20 mA output for remote testing