Warco BH600 lathe 240 volts

Warco BH600 metal turning lathe. It's powered by a 2hp single phase motor (so it plugs directly into the normal domestic mains electric). It has had very little use, apart from the bed way (which is induction hardened) the cross slide and the top slide are lovely and tight 12 speeds It's also a screw cutting lathe which is capable of cutting both metric and imperial threads. The gearbox on the front of the machine makes it easy to select the correct speed for screw cutting. 38mm through the headstock It also has a powered cross feed Tail stock is a Morse taper 3 (MT3) As it can be seen, accompanying the lathe are a fixed steady, a travelling steady and a 4 jaw chuck. These accessories on their own could have a value of around £500 . For moving, the lathe does dismantle into two parts, the cabinet and the lathe itself. Help is available to load it onto a small trailer or into a van. It's located in Newtownards, Co. Down. Contact Damien on 0044 7970 777 686 between 8am and 11pm. Euros accepted at an exchange rate of €1.16 = £1 Sunday callers are welcomed